130+ kg·cm Servo Motors
These are the frames we build above 130 kg·cm — from 12.7 N·m at the bottom of the range to 96 N·m at the top. Above this line a servo stops being a component you bolt to a bracket and becomes part of the structure: the output shaft carries enough torque to bend a light arm, stall current is measured in tens of amps, and the case is the heat path rather than a cover.
Three things decide the selection at this level. First, whether the joint needs peak or continuous torque. Every figure we publish is a locked-shaft peak released immediately, and holding a load against gravity is a different problem from moving it. Second, the supply: a 700 kg·cm unit draws 22.5 A at stall, so the pack, the fuse and the connector are chosen from the current column, not the torque column. Third, whether the mechanism has its own end stops — most frames this size ship with no mechanical limit, so the controller owns the travel and an over-travel bends metal rather than stalling quietly.
Every frame here is available on PWM, TTL, CAN or RS-485 Modbus with the same mechanics, spline and mounting, so a late change of protocol does not force a mechanical redesign. Below 130 kg·cm the 60–130 kg·cm band covers the same job at lower current.
The group runs from the XQ-S9130D at 130 kg·cm (12.7 N·m) up to the XQ-S9750DC at 980 kg·cm (96.1 N·m), with case masses from 411 g to 1750 g. Interfaces in this group: CAN, PWM, RS485, TTL.
Showing 1–12 of 36 results
-
130+ kg·cm Servo Motors
Side-Mount Brushless Servo S9450FTTL 700kg (68.6 N·m) 30V 895g TTL
Read more -
130+ kg·cm Servo Motors
Side-Mount Brushless Servo RS9450FMB 700kg (68.6 N·m) 30V 895g Modbus
Read more











